Partitions B & C Communications

Cargo

Trunk & Cargo Area Organizers

Pro-gard’s Trunk and Cargo Area Organizers are expertly designed for individual vehicles. Our heavy-duty organizers fit seamlessly into the contours of the spare tire well, taking advantage of the under-utilized space in police vehicles. The lightweight ABS construction is extremely durable, allows for easy access to contents, and provides maximum protection while the vehicle is in motion.

KP-DG25-SS Dodge Ram 3 Piece Kick Panel Assembly

Three-piece lower kick panel assembly for full-size recessed partitions

14 ga. CRS construction
Black powder coat wrinkle finish
Driver and passenger side panels have three (3) pressed PEM studs
Center panel has two flanged sides
All panels have slotted holes to adjust during installation
Seals gap between partition and vehicle floor
Use with recessed full-size partition only

Fold Down Sliding Trunk Tray

The FDRS-FPIU-SA is an innovative lockable equipment mounting solution for the Interceptor Utility Cargo Area.

The FDRS-FPIU-SA Fold Down Rear Tray is 40” x 15” with a 37” x 14” Slide Out tray. It creates a false wall behind the rear seat and provides a convenient and protected mounting area for trunk mounted electronics.

The fold down design allows easy access for service in the down position while protecting electronic equipment in the upright position.

Standalone

IPER™ Shield Enhanced Space Saver Partitions

The VIPERTM Shield Rapid Deployment System takes protection outside of the vehicle with the officer. This lightweight shield is capable of providing protection for officers against the uncertainties they face daily; situations like warranty service, felony stops, domestic disputes, or even routine traffic stops that can quickly escalate.

AC-FDUV-30-HC Ford Police Interceptor Utility 30″ Console Floor Plate

30″ Ford Police Interceptor Utility specific console floor plate

11 ga. CRS
30″ long floor plate (same length as OEM floor plate design)
Replaces OEM floor plate
Pre-punched w/slotted holes for easy installation of consoles and accessories
Pre-punched with 2″ dia. wire pass-through hole
Compatible with Ready-for-the-Road PI Utility model
Available also in 25″ length (to accommodate weapon mounts on partitions)
For model year 2017, OEM floor plate has module bolted to it. Future PIU mounts will have bolt holes to re-locate module

Fold Down Sliding Trunk Tray

The FDRS-SUV-SA is an innovative lockable equipment mounting solution for most SUV’s with a cargo mounted partition.

The FDRS-SUV-SA Fold Down Rear Tray is 40” x 15” with a 37” x 14” Slide Out tray. It creates a false wall behind the rear seat and provides a convenient and protected mounting area for trunk mounted electronics.

The fold down design allows easy access for service in the down position while protecting electronic equipment in the upright position.